Extreme Networks AltitudeTM 4522 Series Guide d'installation télécharger pdf (Page 40)

Chapter 3: Initial Access Point Configuration

Altitude™ 4522 Series Access Point Installation Guide

16 Set the following DHCP and Static IP Address/Subnet information for the WAN

interface:

●

Use DHCP - Select the checkbox to enable an automatic network address

configuration using the Access Point’s DHCP server.

●

Static IP Address/Subnet - Enter an IP Address/Subnet and gateway for the Access

Point's WAN interface. These are required fields

●

The port connected to the WAN - Select the port used as the physical Access Point

connection to the external network. The ports available differ depending on the

Access Point model deployed. Access Point models with a single port have this

option fixed.

●

Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between

the Access Point's WAN and LAN interfaces.

17 Select Next. The Initial AP Setup Wizard displays the Radio Configuration screen to define

support for the 2.4GHz radio band, 5GHz radio band or to set the radio's functionality

as a dedicated sensor.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

Pas de commentaire

Extreme Networks AltitudeTM 4522 Series Guide d'installation Page 40