Extreme Networks AltitudeTM 4522 Series Guide d'installation télécharger pdf (Page 27)

Altitude™ 4522 Series Access Point Installation Guide

CHAPTER

Initial Access Point

Configuration

Once the Access Point is installed and powered on, complete the following steps to get the

device up and running by using the Initial Setup Wizard:

1 Attach an Ethernet cable from the Access Point to a controller with an 802.3af compatible

power source or use the PWRS-14000-148R power supply to supply power to the

Altitude 4522 Access Point (once fully cabled).

If your host system is a DHCP server, an IP address is automatically assigned to the

Altitude 4522 Access Point and can be used for device connection. However, if a DHCP

server is not available, you will need to derive the IP address from the Altitude 4522

Access Point MAC address. Using this method, the last two bytes of the Altitude 4522

Access Point MAC address become the last two octets of the IP address.

For Example:

MAC address - 00:C0:23:00:F0:0A

IP address equivalent - 169.254.240.10

To derive the Altitude 4522 Access Point’s IP address using its factory assigned MAC

address:

a Open the Windows calculator be selecting Start > All Programs > Accessories >

Calculator. This menu path may vary depending on your version of Windows.

b With the Calculator displayed, select View > Scientific. Select the Hex radio button.

c Enter a hex byte of the Altitude 4522 Access Point’s MAC address. For example, F0.

d Select the Dec radio button. The calculator converts F0 into 240. Repeat this process

for the last Altitude 4522 Access Point MAC address octet.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 67 68

Pas de commentaire

Extreme Networks AltitudeTM 4522 Series Guide d'installation Page 27