Extreme Networks Summit WM Series Guide de l'utilisateur télécharger pdf (Page 37)

Setting up OSPF Routing

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

Ensure that the OSPF parameters defined here for the Summit WM-Series Switch are consistent with the

adjacent routers in the OSPF area. The parameters include the following:

● If the peer router has different timer settings, the protocol timer settings in the Summit WM-Series

Switch must be changed to match, in order to achieve OSPF adjacency.

● The MTU of the ports on either end of an OSPF link must match. The MTU for ports on the Summit

WM-Series Switch is defined as 1500, in the IP Addresses screen, during data port setup. This

matches the default MTU in standard routers.

Setting up OSPF Routing on the Summit WM-Series Switch

1 Click on the OSPF tab in the Routing Protocols screen. The OSPF Settings screen appears.

2 In the Global Settings area, enable OSPF by filling in the following fields:

3 To save these settings, click on the Save button.

OSPF Status: To enable OSPF, select ON from the drop-down list.

Router ID: If left blank, the OSPF daemon will automatically pick a router ID from one

of the Summit WM-Series Switch’s interface IP addresses.

If filled in here with the IP address of the Summit WM-Series Switch, this ID

must be unique across the OSPF area.

Area ID: 0 is the main area in OSPF

Area Type: Select Default (Normal), Stub, or Not-so-stubby (OSPF area types) from the

drop-down list.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 227 228

Pas de commentaire

Extreme Networks Summit WM Series Guide de l'utilisateur Page 37