Extreme Networks e" series Guide d'installation télécharger pdf (Page 27)

Evaluating and Meeting Cable Requirements

Consolidated "e" Series Hardware Installation Guide 27

Figure 1: Properly secured rack (SPG_007 redraw with e series in the rack)

Brace open distribution racks if the channel thickness is less than 1/4 inch (6.4 mm).

Evaluating and Meeting Cable Requirements

This section addresses requirements for the that cable you should use when installing your network

equipment. It includes:

• Cabling Standards

• Cable Labeling and Record Keeping

• Installing Cable

• RJ-45 Connector Jackets

• Radio Frequency Interference

Cabling Standards

We recommend using the BICSI (Building Industry Consulting Service International) RCDD (Registered

Communications Distribution Designer), which is globally recognized as a standard in site planning and

cabling. For information, go to http://www.bicsi.org

SPG_00

Secure to floor

with 3/8 inch lag screws or bolts

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 111 112

Pas de commentaire

Extreme Networks e" series Guide d'installation Page 27